While the teak job in the cockpit is drying, Alex is now installing compression tubes from a new carbon floor he's done (located between his right foot and the engine in the image), to the beam above to stiffen the boat additionally. We just got the two stainless steel tubes with mountings welded and delivered and they shall be in place here shortly. Here he's adjusting the exhaust pipe from the engine so it all will room close to one another. There's normally an insulated table covering the engine, which is located in the middle of the saloon, right above the keel. That table will be redesigned one day too, when these first more structural and important parts are in place. You can see the compression tubes laying on the floor towards our cabin.